Photo: Eren Li

What does putting baking soda in chili do?

Let the beef mixture sit for 20 minutes. The baking soda raises the pH of the meat, helping to lock in moisture and accelerate browning. (I borrowed this tenderizing trick from Cook's Illustrated; it works like a charm.)

onceuponachef.com - Classic Beef Chili - Once Upon a Chef

How can I remove eye bags permanently at home?

The following tips can help you reduce or eliminate bags under your eyes: Use a cool compress. Wet a clean washcloth with cool water. ... Cut down...

Last updated Sep 28, 2022

Can you eat half a banana on keto?

Because of the sugar content in bananas, they are considered to not be keto. If you are an athlete that practiced the Targeted Ketogenic Diet...

Last updated Mar 21, 2018

Promotion

This post may contain affiliate links. Read my full disclosure policy.

This beef chili is melt-in-your-mouth tender, thick, and rich. Serve it over rice or scoop it up with tortilla chips. Beef chili is a cold weather mainstay at my house, and this is my go-to recipe. It’s melt-in-your-mouth tender, thick, and rich – perfect to serve over rice or pasta or scoop up with tortilla chips. I don’t add any beans, as my kids tend to eat around them, but feel free to add a can of your favorite drained beans for the last half hour of cooking, if you like. Note that the recipe calls for 85% lean ground beef. Please don’t use extra-lean beef or drain off the fat after browning the meat; the fat bastes the meat during cooking, adding richness and flavor, and you can skim it all off at the end. Chili is a meal unto itself, but you can never go wrong with cornbread or chips and guacamole on the side.

What You’ll Need To Make Classic Beef Chili

Step-by-Step Instructions

Begin by combining the ground beef, salt, baking soda, and water in a large bowl. Using your hands, mix until evenly combined. Let the beef mixture sit for 20 minutes. The baking soda raises the pH of the meat, helping to lock in moisture and accelerate browning. (I borrowed this tenderizing trick from Cook’s Illustrated; it works like a charm.)

Meanwhile, chop the veggies.

I use a food processor to speed this up, but it’s fine to chop by hand too. In a large pot over medium heat, heat the oil and add the onions, garlic, and red pepper.

Cook, stirring frequently, until softened, 4 to 6 minutes.

Cook, stirring with wooden spoon to break up the meat, until the beef is browned, 10 to 12 minutes. The beef will release a lot of fat and liquid — do not drain it; you’ll skim the fat off at the end. Add the ancho chili powder, chipotle chili powder, cumin, oregano, coriander, smoked paprika, and cinnamon. Cook, stirring frequently, for 1 to 2 minutes, until well combined and fragrant.

Bring to a boil.

Reduce the heat to low and simmer, covered, for 2 hours. Skim any excess fat off of the surface of the chili — there will be quite a bit. Stir in the lime juice, then taste and adjust seasoning, if necessary. Serve with accompaniments and enjoy! Did you make this recipe? I'd love to know how it turned out! Please let me know by leaving a review below. Or snap a photo and share it on Instagram; be sure to tag me @onceuponachef.

Which beans are keto-friendly?

Keto-friendly beans On a strict keto diet, your best bet for beans is to choose either green beans or black soybeans. While green beans are...

Last updated Oct 7, 2022

What happens if you don't eat carbs for 2 weeks?

Severe carb restriction can cause your body to break fat down into ketones for energy. This is called ketosis. Ketosis can cause side effects such...

Last updated Sep 5, 2019

Promotion

What does vinegar add to chili?

Stirred into the pot right before serving, a spoonful of vinegar brightens up the finished product, and gives it that full, rounded taste that was missing. Even if the chili recipe you're using doesn't call for vinegar, go ahead and add it anyway. You won't actually taste the tang or sharp flavor of the vinegar.

thekitchn.com - The Pantry Staple You Should Be Adding to Every Pot of Chili | Kitchn

Good news, it’s easier than you think to perk up your pot of chili. All it takes is a splash of vinegar, which I bet you already have in the pantry. Stirred into the pot right before serving, a spoonful of vinegar brightens up the finished product, and gives it that full, rounded taste that was missing. Even if the chili recipe you’re using doesn’t call for vinegar, go ahead and add it anyway. You won’t actually taste the tang or sharp flavor of the vinegar. A splash is just enough to compliment the tomato-kissed broth and brighten up the flavors of the ingredients in the pot.

What if my pee smells like food?

This is normal, and nothing to be concerned about. Small fluctuations in odor — usually caused by what you've eaten and how much you've had to...

Last updated Apr 27, 2022

What does a FUPA look like?

A FUPA looks like an extra layer of skin and fat just above the pubis. Some people have a larger mons pubis because of genetics. FUPA can also...

Last updated Feb 5, 2021

Promotion

What flavor does butter add?

Butter has a flavor all its own. Generally, butter is soft, creamy, and rich, with just a hint of sweetness, which is why the word "buttery" is...

Last updated May 12, 2021

Promotion

How to lose 2kg in 10 days?

Eat more fibre, cut added sugars “Increase intake of vegetables, salads and soups. Dedicate one meal only to vegetables or sprouts. Cut back on...

Last updated Dec 1, 2020